GE GHDS830EDWS Technical Service Manual

Also see for GHDS830EDWS: Manual

GE GHDS830EDWS Technical Service Manual Manual pdf 21 page image

– 21 –To remove the drum:1. Remove the belt from the motor pulley and idlerpulley. (See To remove the drive belt, followsteps 1 through 3.)2. Using the belt as a handle, pull the drumforward and guide it out of the dryer cabinet.Note: Before installing the front panel, slowly rotatedrum in both directions to ensure belt is aligned andnot twisted.Caution: To prevent damage to the dryer, the drummust be installed with the blue threaded felt sealtoward the back of the dryer.Blue ThreadDrum RollersThe stainless steel drum rotates on 4 drum rollers (2on the front drum support and 2 on the rear drumsupport).Each drum roller comes as a complete assembly.To remove the drum rollers:1. Remove the front bulkhead to access the frontdrum rollers. Remove the drum (See Drive Beltand Drum), to access the rear drum rollers.2. Each drum roller is held in place by a plastictriangular clip. Remove the triangular clip with asmall flat-bladed screwdriver and slide the drumroller off the roller shaft.To remove the left side drum roller shaft from thefront bulkhead:1. Remove the front bulkhead. (See Front Bulkhead.)2. Remove the 9/16-in. hex nut that attaches theshaft to the front bulkhead.To remove the right side drum roller shaft fromthe front bulkhead:1. Remove the front bulkhead. (See Front Bulkhead.)2. Remove the lint filter.3. Disconnect the sensor wires.Note: The sensor rods are part of the lint filterhousing. To replace the sensor rods, the lint filterhousing must be replaced.(Continued Next Page)