GE GHDS830EDWS Technical Service Manual

Also see for GHDS830EDWS: Manual

GE GHDS830EDWS Technical Service Manual Manual pdf 17 page image

– 17 –Dryer ComponentsWARNING: Sharp edges may be exposed whenservicing the dryer. Use caution to avoid injury.Wear Kevlar® gloves or equivalent protection.Note: Combined Phillips-head/square-drive recessscrews are utilized throughout this appliance. EitherPhillips or square-drive screwdrivers can be used toextract or install these screws.3. Remove the three 1/4-in. hex-head screws thatattach the control panel to the main top.4. Push the control panel back and remove it fromthe 2 shoulder screws attached to the main top.5. Carefully hang the control panel over the backof the dryer.Control PanelRemoval of the control panel provides access to thecontrol board assembly. The control panel is held inplace with 3 screws located below the control panelchrome trim and 2 key slots inside the control panelthat engage 2 shoulder screws attached to the maintop.To remove the control panel:1. Insert a flat blade screwdriver and press in eachof the 2 release tabs (1 on each side) and slidethe chrome trim forward from the control panel.2. Remove the chrome trim from the control panel.Tab