GE GLD6500LWW/CC/BB Installation Instructions Manual

Contents

• Connect drain line to air gap, waste tee or disposerusing the previously determined method. Secure hosewith a screw type clamp.Waste Tee InstallationMethod 1 – Air gap with waste tee or disposerDisposer InstallationWaste Tee InstallationMethod 2 – “High drain loop” with waste tee or disposerWith this method you will need the drain hose hanger set asidein Step 1.Fasten drain hose to underside of countertop with the providedhanger.Disposer InstallationFigure YFigure ZIMPORTANT – When connecting drain line todisposer, check to be sure that drain plug has been removed.DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.756Dia60 756Dia61Dishwasher InstallationSTEP 17: CONNECT DRAIN LINEThe molded end of the drain hose will fit 5/8" through 1"diameter inlet ports on the air gap, waste tee or disposer.• Determine size of inlet port• Cut drain hose connector on the marked line, if required, to fitthe inlet port.• If a longer drain hose is required and you did not purchasedrain hose GPF10L, add up to 42" length for a total of 120"(10 feet) to the factory installed hose. Use 5/8" or 7/8" insidediameter hose and a coupler to connectthe two hose ends.Secure theconnectionwith hoseclamps.Figure WFigure XNote: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10 FEETFOR PROPER DRAIN OPERATION.�� RemoveDrainPlug1871 Art1Tip: Avoid unnecessary service call charges for a no draincomplaintMake sure excess drain hose has been pulled throughthe cabinet opening. This will prevent excess hose in thedishwasher cavity from becoming kinked or crushed by thedishwasher.STEP 16: CONNECT WATER SUPPLYConnect water supply line to 90° elbow.• Slide compression nut, then ferrule over end of water line.• Insert water line into 90° elbow.• Slide ferrule against elbow and secure with compression nut.IMPORTANT – Check to be sure that door springand/or door spring cable do not rub or contact the fill hose orwater supply line.Test by opening andclosing the door.Re-route the watersupply lines if arubbing noise orinterferenceoccurs.Figure V 90° ElbowFerrule90° ElbowDoor Spring756Dia57Hot WaterSupply LineCompressionNut1871 Art4Cutting Line1" 5/8"IMPORTANT: Do not cut corrugatedportion of hose18"Min.32"Min.05D-1294C32"Min.18"Min.05D-1294BDrain Hose Hanger11