GE GLD6500LWW/CC/BB Installation Instructions Manual

Contents

Dishwasher InstallationSTEP 20: DISHWASHER WET TEST■ Turn on power supply or plug power cord into outlet,Turn on power supply or plug power cord into outlet,if equipped.■ Latch door.Latch door.■ Push “Rinse Only” pad.Push “Rinse Only” pad.■ Push Start/Reset pad one time. Dishwasher should start.Push Start/Reset pad one time. Dishwasher should start.■ Check to be sure that water enters the dishwasher. If waterCheck to be sure that water enters the dishwasher. If waterdoes not enter the dishwasher, check to be sure that waterand power are turned on.■ Check for leaks under the dishwasher. If a leak is found,Check for leaks under the dishwasher. If a leak is found,turn off power at the breaker, and then tighten waterconnections. Restore power after leak is corrected.■ Check for leaks around the door. A leak around the doorCheck for leaks around the door. A leak around the doorcould be caused by door rubbing or hitting againstadjacent cabinets. Reposition the dishwasher if necessary.See Step 15.■ The dishwasher will drain and turn off about 5 minutes afterThe dishwasher will drain and turn off about 5 minutes afterit was started. Check drain lines. If leaks are found, turn offpower at the breaker and correct plumbing as necessary.Restore power after corrections are made. See Steps 7and 17.■ Open dishwasher door and make sure most of the waterOpen dishwasher door and make sure most of the waterhas drained. If not, check that disposer plug has beenremoved and/or air gap is not plugged. Also check drainhose to be sure it is not kinked underneath or behinddishwasher. See Step 17.■ Press Start/Reset pad once again and run dishwasherPress Start/Reset pad once again and run dishwasherthrough another “Rinse Only” cycle. Check for leaks andcorrect if required.Figure CCSTEP 21: REPLACE TOEKICK• Place toekick against the legs of the dishwasher.05A-1183CAttachmentScrewsToekick• Align the toekick with the bottom edge and make sure it isagainst the floor.• Insert and tighten the two toekick attachment screws. Thetoekick should stay in contact with the floor.Tip: Reduce sound from under the dishwasherMake sure toekick is against floor.STEP 22: LITERATURE• Be sure to leave complete literature package, theseInstallation Instructions and product samples and/or couponswith the consumer.13

/ 16

Related manuals for GE Built-In Dishwashe