GE GLD6500LWW/CC/BB Installation Instructions Manual

Contents

Dishwasher InstallationFigure G• Screw leveling legs back into the dishwasher frame,approximately 1/8" from frame as shown.756Dia39 923-10BApprox.1/8"625Dia30CAUTIONCAUTIONCAUTIONCAUTIONCAUTIONDo not remove wood base until you areready to install the dishwasher. The dishwasher willtip over when the door is opened if base is removed.STEP 3: REMOVE WOOD BASE,INSTALL LEVELING LEGSIMPORTANT – Do not kick off wood base!Damage will occur.• Move the dishwasher close to the installation location and layit on its back.• Remove the four leveling legs on the underside of the woodbase with a 15/16" socket wrench.• Discard base.STEP 2: CHECK DOOR BALANCE• With dishwasher on the wood base, check the door balanceby opening and closing the door.• Door is properly balanced if it gently drops from a 1/2 openposition and does not rise from the full open position.• If necessary increase or decrease tensionas shown. Latch door and adjust both springsto the same tension setting to correct balance.Tip: Make sure door opens and closes smoothlyCheck door opening and closing. If door does not open easilyor falls too quickly, check spring cable routing. The cable is heldin place by “shoulders” on the pulley. Check to be sure cablehas not slipped over the pulley shoulders.IncreaseSpringTensionDecreaseSpringTensionCorrectIncorrectInsert HookOver Bracket05A-1182NSTEP 1: PREPARATIONLocate the items in the installation package and set aside foruse in the listed steps:• Screw kit – Steps 5 or 18 and 15• Junction box cover – Step 5 or 18• Drain hose and clamp – Step 7• Drain hose hanger – Step 17• Trim pieces (some models) – Step 11• Owner's Manual - Steps 19 and 22• Product Samples and/or coupons – Step 22Figure HToekickRemove 2Toekick Screws923-02PSTEP 4: REMOVE TOEKICK• Remove the 2 toekick screws and toekick. Set aside for use inStep 21.Figure I6