GE GLD6500LWW/CC/BB Installation Instructions Manual

Contents

212Dia9Power Cord(If Used)InsulationBlanket WaterLineMaximum Drain HoseLength 10'HouseWiringDrainHoseFigure NSTEP 9: INSTALL DRAIN HOSE,THROUGH CABINET• Position dishwasher in front of cabinet opening. Insert drainhose into the hole in cabinet side. If a power cord is used,guide the end through a separate hole.STEP 8: POSITION WATER LINEAND HOUSE WIRING• Position water supply line and house wiring on the floor of theopening to avoid interference with base of dishwasher andcomponents under dishwasher.Figure M661Dia32WaterLine HouseWiring5" 5"4" 4"6"6"4"Tip: Prevent unnecessary service call charges for no fi ll,drain or noise concernsPosition utility lines so they do not interfere with anythingunder or behind the dishwasher.Dishwasher InstallationSTEP 10: SLIDE DISHWASHERTHREE-FOURTHS OF THE WAYINTO CABINETIMPORTANT – Do not push against front panelwith knees. Damage will occur.• Grasp the sides of the front panel and slide dishwasher intothe opening a few inches at a time.• As you proceed, pull the drain hose through the openingunder the sink. Stop pushing when the dishwasher extendsabout 6 inches forward of adjacent cabinets.• Make sure drain hose is not kinked under or behind thedishwasher.• Make certain the house wiring, drain line and water line donot interfere with components under dishwasher.Figure OFigure PSTEP 11: INSTALL TRIM PIECES(some models)Skip this step if trim is not supplied with the dishwasher.In this step you will need the trim pieces set aside in Step 1.• Position the trim pieces so the lips face toward thedishwasher door.• Select a long trim piece and press it onto the left side tubflange. Start with the top edge and press the trim piececompletely onto the tub flange as you move towards thebottom. Repeat for the right side tub flange trim piece.• Install remaining trim piece on the top tub flange.��8