GE GSD2900 Series Use And Care Manual

Also see for GSD2900 Series: Use and care guide

Contents

Good Dishwashing Starts with HOT WaterTo get dishes clean and dry, you need hot water. For good washing and drying,the entering water must be at least 120°F. To prevent dish damage, inlet water shodd not exceed 150°F.How to Test Water TemperatureCheck your water temperature with a candy or meat Helpful hints: If outside temperatures are unusuallythermometer. Turn on the hot water faucet nearest low, or if your water travels a long distance from waterthe dishwasher. Put the thermometer in a glass and heater to dishwasher, you may need to set your waterlet the water run continuously into the glass until the heater’s thermostat up. If you have not used hot watertemperature stops rising. If the water temperature is for some time, the water in the pipes will be cold. Turnbelow 120°F., adjust your water heater. on the hot water faucet at the sink and allow it to rununtil the water is hot. Then start the dishwasher. Ifyou’ve recently done laundry or run hot water forshowers, give your water heater time to recover beforeoperating the dishwasher.To improve washability if the water is less than 120°F.and you cannot adjust your water heater: Select alonger cycle or WASH HEAT BOOST option and fillboth detergent cups at least half-full with detergent.How to Use a Rinse AgentThe rinse agent makes water flow off dishesquicker than usual. This lessens water spottingand makes drying faster, too.For best dishwashing performance, use of a rinseagent such as JET-DRY brand is recommended.Rinse agents come in either liquid or solid form.Your dishwasher uses the liquid form.How to fill the rinse agent dispenser.Unscrew the cap.Add liquid rinse agentuntil it just reaches thebottom of lip inside thedispenser opening. Q@; : ~Replace cap. Thedispenser automatically4L/“/releases rinse agent intofinal rinse water.You may check to see if you need to add rinse agent byremoving the fill. cap and looking into the container.You may also check the rinse agent, on some models,by pressing the clear center of the fill cap 2 or 3 times.If rinse agent is drawn into the center of the fill cap,you have enough. If the center area remains clear addrinse agent.Your dishwasher’s rinse agent container holdsapproximately 4X ounces. This should last about3 months. Fill as needed.If you accidentally spill: Wipe up the rinseagent with a damp cloth. Don’t leave the spill in thedishwasher. It can keep your detergent from working.If you can’t find any rinse agent, write:BENCKISER CONSUMER PRODUCTS, INC.(“JET-DRY” )Corporate Centre 155 Federal RoadP.O. Box 1991Danbury, CT 06813 199111