GE J2BP85 Owner's Manual & Installation Instructions

Also see for J2BP85: Dimensions and installation information Installation and owner's instructions

Oven Control, Clock and Timer FeaturesBAKE PadTouch this pad to select the bake function.NOTE: For gas only baking hold the BAKE pad for3 seconds.BROIL HI/LO PadTouch this pad to select the broil function.DisplayShows the time of day, oven temperature,whether the oven is in the bake, broil orself-cleaning mode and the times set forthe timer or automatic oven operations.It will also show warming drawer settings.If “F– and a number or letter” flash in the display and theoven control signals, this indicates a function error code.If your oven was set for a timed oven operation anda power outage occurred, the clock and all programmedfunctions must be reset.The time of day will flash in the display when there has beena power outage. Reset the clock.If “Err” appears in the display, you have tried to set a time ortemperature outside of the control’s limits. Touch CLEAR/OFFpad and enter a new setting.If the function error code appears during the self-cleaningcycle, check the oven door latch. The latch handle may havebeen moved, even if only slightly, from the latched position.Make sure the latch is moved to the right as far as it will go.Touch the CLEAR/OFF pad. Allow oven to cool for one hour.Put oven back into operation. If function error code repeats,disconnect power to range and call for service.CLEAR/OFF PadTouch this pad to cancel ALL oven operationsexcept the clock and timer, and warmingdrawer settings.COOKING TIME PadTouch this pad and then touch the numberpads to set the amount of time you want yourfood to cook. The oven will shut off when thecooking time has run out.DELAY START PadUse along with COOKING TIME or SELF CLEANpads to set the oven to start and stopautomatically at a time you set.OVEN LIGHT PadTouch this pad to turn the oven light onor off.TIMER/CLOCK PadTouch this pad to select the timer feature.Touch and hold this pad, until the displaychanges, to set the clock.START PadMust be touched to start any cooking orcleaning function, and warming drawer settings.Number PadsUse to set any function requiring numberssuch as time of day on the clock, timer, oventemperature, internal food temperature, starttime and length of operation for timedbaking and self-cleaning.WARMING DRAWER PadTouch this pad and then touch numberpads 1–3 to use the warming drawer. See theUsing the electric warming drawer section.SELF CLEAN PadTouch this pad to select self-cleaningfunction. See the Using the self-cleaningoven section.Using the oven controls. ge.com11Consumer SupportOperating InstructionsSafety Instructions Installation Instructions Troubleshooting Tips