GE J2BP85 Owner's Manual & Installation Instructions

Also see for J2BP85: Dimensions and installation information Installation and owner's instructions

To Set the ClockThe clock must be set to the correct time ofday for the automatic oven timing functionsto work properly. The time of day cannotbe changed during a timed baking orself-cleaning cycle.Touch and hold the TIMER/CLOCK paduntil the display changes.Touch the number pads.Touch the number pads the same way youread them. For example, to set 12:34, touchthe number pads 1, 2, 3 and 4 in that order.If number pads are not touched within oneminute after you touch the CLOCK pad, thedisplay reverts to the original setting. If thishappens, touch the CLOCK pad and reenterthe time of day.Touch the START pad until the time ofday shows in the display. This entersthe time and starts the clock.To check the time of day when the display isshowing other information:Touch and hold the TIMER/CLOCK pad until thetime of day is displayed. The time of day showsuntil another pad is touched.To Set the TimerThe timer does not control oven operations.The maximum setting on the timer is 9 hoursand 59 minutes.Touch the TIMER/CLOCK pad.Touch the number pads until theamount of time you want shows in thedisplay. The maximum time that canbe entered in minutes is 59. Timesmore than 59 minutes should bechanged to hours and minutes. Forexample, to enter 90 minutes as 1hour 30 minutes, touch 1, 3 and 0 inthat order.If you make a mistake, touch the TIMER/CLOCKpad and begin again.Touch the START pad. After pressingthe START pad, SET disappears; thistells you the time is counting down,although the display does not changeuntil one minute has passed.When the timer reaches :00, thecontrol will beep 3 times followedby one beep every 6 seconds untilthe TIMER/CLOCK pad is touched.The 6 second tone can be canceled by followingthe steps in the Special features of your ovencontrol section under Tones at the End ofa Timed Cycle.Using the clock and timer.Operating Instructions Safety InstructionsInstallation InstructionsTroubleshooting TipsConsumer Support16Make sure the clock is set to thecorrect time of day.HOLD 3 SEC. TOSET CLOCKThe timer is a minute timer only.The CLEAR/OFF pad does not affectthe timer.HOLD 3 SEC. TOSET CLOCK+