GE JBP22GR Use And Care & Installation Manual

Also see for JBP22GR: Use, care & installation guide

GE JBP22GR Use And Care & Installation Manual Manual pdf 23 page image

Drip PansSurface Unit‘Drip PanTo remove the drip pans for cleaning. the surface unitsmust be removed first. Lift the surface unit about oneinch above the drip pan and pull it out. Make sure thesurface units are completely cool bejbre touchingthem. Clean the drip pans with soap and water, plasticscouring pad or in the dishwasher. DO NOT CLEANIN SELF-CLEANING OVEN; pans will discolor.Wipe after each cooking so unnoticed spatter will notburn on the next time you cook.Do not lift the surface unit more than one inch. Ifyou do, it may not lie flat on the drip pan when youplug it back in.Repeated lifting of the surface unit more than oneinch above the drip pan can permanently damagethe receptacle.To replace a surface unit:l Replace the drip pan into the recess in the cooktop.Make sure opening in the pan lines up withthe receptacle.l Insert the terminals of the surface unit through theopening in the drip pan and into the receptacle.l Guide the surface unit into place so it rests evenly.Do not cover the drip pans with aluminum foil. Usingaluminum foil so close to the receptacle could causeshock, fire or damage to the range.Cooktop Surface Lamp (on some models)When changing a cooktop lamp, do not touch the To replace:metal at the ends of the lamp. l Place fingers on the top‘l’he cook(op li~ht is easily replaced with a fluorescent each end of the lamp.neartube of the ~an;e wattage._ Be~”ore changing the lamp, l Press the lamp into the slotspLl\] the p]LIg to the range or disconnect the power at the until it snaps into place.main fuse or circuit breaker panel. l Move lamp cover down andTo remove: snap into place.lllLift the lamp cover by pulling the bottom edge towardyou tind then up.Place fingers on top near each end of the lamp.RtJll the top of the lamp gently toward the front of therange and ~ently pull the-lamp from the socket,making sure it does not hit the lamp cover.Oven VentThe oven is ~ented through an opening under the rightrear surface unit. Never cover the opening withaluminum foil or any other material. This wouldprevent the oven vent from working properly.Vent(continued next page)23