INSTALLATION INSTRUCTIONSBEFORE YOU BEGINRead these instructions completelyand carefilly.IMPORTANT: Save these instructions forthe local electrical inspector’s use.IMPORTANT: OBSERVE ALL GOVERNINGCODES AND ORDINANCES.NOTE TO INSTALLER: Leave theseinstructions with the appliance afterinstallation is completed.NOTE TO CONSUMER: Keep this Use andCare Guide and Installation Instructions forfuture use.NUIT3: This appliance must be properlygrounded.TOOLS YOU WILL NEEDLarge blade screwdriverChannel lock pliers or small ratchet wrench with3/16” socket (for leveling range)ELECTRICAL REQUIREMENTSCAUTION, FOR PERSONAL SAF131Y:DO NOT USE AN EXTENSION CORD WITHTHIS APPLIANCE.REMOVE HOUSE FUSE OR OPENCIRCUIT BREAKER BEFORE BEGINNINGINSTALLATION.This appliance must be supplied with the propervoltage and tiequency, and connected to anindividual, properly grounded branch circuit,protected by a circuit breaker or time delay fuse, asnoted on the rating plate.Wiring must conform to National Electric Codes.Lf the electric service provided does not meet theabove specifications, it is recommended that alicensed electrician install an approved outlet.Because range terminals are not accessible afterrange is in position, flexible service conduit or cordmust be used.26STEP 1PREWRE THE OPENING1%” spacing is recommended from the range toadjacent vertical walls above cooktop surface.Allow 30” minimum clearance between surfaceunits and bottom of unprotected wood or metaltop cabinet, and 15” minimum betweencountertop and adjacent cabinet bottom.To eliminate the risk of burns or fire by reachingover heated surface units, cabinet storage spaceabove the surface units should be avoided. Ifcabinet storage is to be provided, the risk can bereduced by installing a range hood that projectshorizontally a min. of 5“ beyond the bottom ofthe cabinets.NOT LESS THANWIDTH OF RANGEi, /Iu30” -MIN. 15JMIN.//0 LOCATEI I I \ I OUTLET BOXWITHIN EITHERSHADED AREAY MIN.INSTALLOUTLET BOXON EITHERSIDE OF Q IJ..———. .——— ———.—— -—