ge.comPossible Causes What To DoControl signals after You forgot to enter a * Touch tile BAKE pad and desired temperature orentering cooking time bake temperature or the SELF CLEAN LO/STD pad and desired clean time.or start time cleaning time.Display goes blank A fuse in your home may * Replace tile tuse or reset tile circuit breaker:be blown or the circuitbreaker tripped.The clock is in the * See tile Special features of your oven control section.black-out mode.Display flashes Power failure. * Reset tile clock.Unable to get the Oven control pads were * Tile BROIL HI/LO and BAKE pads must be touched atdisplayto show "SF" not touched properly, tile same time and held fm 3 seconds."Probe" appears in This is reminding you to * Enter a probe teml)erature.the display enter a probe temperature(on some models) after plugging in the probe.Power outage, Power outage or surge. * Reset tile clock. ]f the oven was in use vet! must resetclock flashes it by, touching, tile CLEAR/OFFpad, ,settiuo_ tile clockand resetting any cooking flu]orion.Steam from the vent When using the convection * This is normal.feature (on some models),it is normal to see steamcoming out of the ovenvent. As the number of racksor amount of food beingcooked increases, the amountof visible stemn will increase."Burning" or "oily"odor emitting fromthe ventThis is normal in a new oven * To speed tile process, set a self-clean cycle for aand will disappear in time. minimum of 3 hem's. See tile Using the self-cleaningo_,en section.Strong odor An odor from the insulation * This is temporaD'.aromad the inside of the ovenis normal for the first few timesthe oven is used.Fan noise A cooling fan or a convectionfan (depending on thefunction you axe using) mayautomatically turn on mzd off.• This is normal. Tile cooling tim will turn off and onto cool internal parts. It u]av _un after tile oven isturned OFF. Tile convection thn (on some models)will cycle on and off until the fimction is over or thedoor is opened.4/