GE JVM1630 Installation Instructions Manual

Also see for JVM1635: Owner's manual Owner's manual

GE JVM1630 Installation Instructions Manual Manual pdf 13 page image

Installation Instructions13USE TOP CABINET TEMPLATEFOR PREPARATION OF TOP CABINETA2RECIRCULATING (Non-Vented Ductless)PopcornConvenience CookingExpress CookPotatoStartPauseCancelOffBeverageReheatSetClockTurntableSurfaceLightVentAdd30 Sec.PowerLevel 0852741963CookTimeDefrostWeight/TimeTimerOn/OffINSTALLATION OVERVIEWA1. Attach Mounting Plate to WallA2. Prepare Top CabinetA3. Install Charcoal Filter (Supplied with JNM3161 andJVM3160 models)A4. Mount the microwave ovenA5. Installing/Replacing the Charcoal Filter WithoutAccess to Top Screws and the Unit Has AlreadyBeen Mounted.• Read the instructions on the TOP CABINETTEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on the TOPCABINET TEMPLATE.CAUTION: Wear safety goggles whendrilling holes in the cabinet bottom.You need to drill holes for the top support screws anda hole large enough for the power cord to fit through.APlace the mounting plate against the wall and insertthe toggle wings into the holes in the wall to mountthe plate.NOTE: Before tightening toggle bolts and wood screw,make sure the tabs on the mounting plate touch thebottom of the cabinet or the horizontal level line whenpushed flush against the wall and that the plate isproperly centered under the cabinet.CAUTION: Be careful to avoid pinchingfingers between the back of the mounting plate andthe wall.Tighten all bolts. Pull the plate away from the wallto help tighten the bolts.3ATTACH THE MOUNTING PLATETO THE WALLA1Attach the plate to the wall using toggle bolts. At leastone wood screw must be used to attach the plate toa wall stud.Remove the toggle wings from the bolts.Insert the bolts into the mounting plate throughthe holes designated to go into drywall and reattachthe toggle wings to 3⁄4″ onto each bolt.14WallMountingPlateSpacing for Toggles MoreThan Wall ThicknessBolt EndToggleBoltToggle WingsTo use toggle bolts:21” = 2.5 cm; 1’ = 0.3 m