GE JVM1630 Installation Instructions Manual

Also see for JVM1635: Owner's manual Owner's manual

GE JVM1630 Installation Instructions Manual Manual pdf 18 page image

18Installation InstructionsMOUNT THE MICROWAVE OVENB5CAUTION: To avoid the risk of personalinjury (back injury or other injuries due to excessiveweight of the microwave) or property damage, youwill need two people to install this microwave.IMPORTANT: Do not grip or use handle duringinstallation.WARNING: Risk of Electric Shock. Cancause injury or death: If installing unit with metalcountertops, cover the edge of the power supplycord hole with the power supply cord bushing.IMPORTANT: If filler blocks are not used, case damagemay occur from overtightening screws.NOTE: When mounting the microwave, thread powercord through hole in bottom of top cabinet. Keep ittight throughout Steps 1–3. Do not pinch cord or liftmicrowave oven by pulling cord.Lift microwave, tilt it forward, and hook slots atback bottom edge onto four lower tabs of mountingplate.Rotate front of microwave oven up against cabinetbottom.12PopcornConvenience CookingExpress CookPotatoStartPauseCancelOffBeverageReheatSetClockTurntableSurfaceLightVentAdd30 Sec.PowerLevel 0852741963CookTimeDefrostWeight/TimeTimerOn/OffPower CordASSEMBLE AND INSTALL ADAPTORB4Place the microwave oven in its upright position, withthe top of the unit facing up and the front of the unitfacing toward you.Remove the screw on the back side of the blowerplate and raise the blower plate off of the microwave.Slide the damper from left to right into the tabs on theblower plate. The yellow tape on the damper shouldbe facing away from you.Remove the yellow tape from the damper. Make surethat the damper pivots easily before mountingmicrowave oven.You will need to make adjustments to assure properalignment with your house exhaust duct after themicrowave oven is installed.Position the blower plate with damper back on themicrowave and secure it with the screws that wereremoved.12345DamperBlowerPlate