GE JVM1630 Installation Instructions Manual

Also see for JVM1635: Owner's manual Owner's manual

GE JVM1630 Installation Instructions Manual Manual pdf 17 page image

17USE TOP CABINET TEMPLATE FORPREPARATION OF TOP CABINETYou need to drill holes for the top support screws,a hole large enough for the power cord to fit through,and a cutout large enough for the exhaust adaptor.B2• Read the instructions on the TOP CABINET TEMPLATE.• Tape it underneath the top cabinet.• Drill the holes, following the instructions on the TOPCABINET TEMPLATE.CAUTION: Wear safety goggles whendrilling holes in the cabinet bottom.Installation InstructionsADJUST BLOWER MOTORADJUST BLOWER MOTOR (cont.)B3B3Remove the screws holding the blower unit andthe screws securing the blower plate. Removethe blower plate from the outer case by sliding ittoward the back of the microwave and pulling up.1Blower PlateBlower Motor ScrewsBlowerMotorScrew2 Carefully pull out the blower unit. The wires willextend far enough to allow you to adjust theblower unit.Roll the blower so that fan blade openings arefacing the top of the oven. Place the blower backinto the opening.Slide the blower plate back onto the microwaveby placing the side tabs into the slots and pushinggently until the back tab is seated into the rear slot.Replace 3 screws.Note: Make sure the wires remain routed through theopenings in the motor frame. To avoid damage tothe fan motor wiring, insert motor carefully such thatthe fan motor wiring does not contact the microwavepower cord bracket.34Back ofMircrowaveRotate 90°Back ofMircrowaveFan BladesWiresWARNING: Risk of Electric Shock.Can cause injury or death. Do not pull or stretch theblower unit wiring. Make sure the wires are notpinched.Side TabSide Slot Rear SlotRear Tab