T~ EX~UST FEATUREThe exhaust hood feature on your microwave oven is equipped with twometal filters which collect grease. When the fan is operated, air is drawnup through the filters and is then discharged through the provided ventingto the outside.METAL I METALFILTER COOKTOp FILTERLIGHTReusable Grease FiltersThe gme filters should be cleaned at least once a month. Never operate the microwave without the filters inplace. In situations where flaming might occur on surfaces below hood, filters will stop the entry of flames into the unit.To Remove Grease Filter To Clean and Replace Grease FilterTo remove grease filter, To clean grease filter, soak it and then agitate filtergrasp the “finger hold” in solution of hot water and detergent. Don’t useon the filter and slide to ammonia or ammonia products because they willthe rear. Then pull filter darken the metal. Light brushing can be used todownward and to the remove embedded dirt.front. The filter willdrop out. Rinse, shake and remove moisture before replacing.To replace grease filter, slide the filter in the frameslot on the back of the opening.Pull filter upward and to the front to lock into place.Charcoal Filter Et (for some mtie]s)There is a Recirculating Charcoal Filter Kit available Filter Kit model JX81 can be ordered from your GEfor models that are not vented to the outside. supplier. Ask for part WB02X4267.GRO~~G ~STRUCTIONSThis appliance must be grounded.In the event of an electrical shortcircuit, grounding reduces the riskof electric shock by providing anescape wire for the electric current.This appliance is equipped with apower cord having a groundingwire with a grounding plug. Theplug must be plugged into an outletthat is properly installed andgrounded. (Fig. 1)WARNING–Improperuse of the grounding plug canresult in a risk of electric shock.PREFERREDMETHODWhere a standard two-prongwall receptacle is encountered, itis your personal responsibility andobligation to have it replaced witha properly grounded three-prongwall receptacle.Do not under anv circumstanceEnsure proper ground cut or remove th~ third (ground)Fig. 1 exists before use prong from the power cord.Consult a qualified electrician or Do not use an adapter plug withthis appliance.service technician if the groundinginstructions are not completely Do not use an extension cordunderstood. or if doubt exists as to with this appliance.whether the appliance is properlygrounded.42