GE JVM192K Use And Care Manual

Also see for JVM 193K: Use and care guide Technician guide

LIGHT BULB REPLACEMENTCooktop LightTo replace thecombinationcooktop light/night light, firstdisconnectpower at mainfuse or circuitbreaker panelor pull plug.REMOVE SCREWRemove screw on right side of light compartmentcover and lower cover until it stops.Oe u e u, stobe!'replaced are coolbefore removing.Break the adhesive __---=--- " = " "seal by gentlyun aoig_g_et _i_alI_ilb s.Replace with 40-wattincandescent bulbs (WB02X4253) available from yourGE supplier. High intensity 40-watt bulbs (40S 11 N/1),which are available in supermarkets and hardwarestores, may also be used for replacements. Raise lightcompartment cover and replace screw. Connectelectrical power to microwave oven.Oven LightTo replace your oven light, firstdisconnect power at main fuseor circuit breaker panel or pullplug. Remove the top grill bytaking out the 2 screws that holdit in placeNext, remove the single screwlocated above door near centerof oven that secures light housing.Replace burned-out bulb witha 40-watt incandescent bulb(WB02X4253), available fromyour GE supplier.Clean off the grease and dust onhood surfaces often. Use a solutionof warm water and detergent.About I tablespoon of ammoniamay be added to the water. Takecare not to touch the filters andenamel surfaces with this solution;ammonia will darken metal.43