GE LP33 Series 80 User Manual

Contents

Modifications reserved Page 33/66OPM_LPS_3UO_80K_M10_1US_V010.doc User Manual LP33 Series 80 & 100 UL S1Code Message Meaning4535 BYPASS LOCKED Transfer on utility not enabled due to settings of respectiveparameters. Contactor K6 is open.4536 BYPASS FREE Settings of respective parameters enable bypass transferon utility. Contactor K6 can be closed.4561 LOAD OFF Key Load Off behind the front door has been pressed, withthe output circuit breaker Q1 closed.4562 DETOUR ON The auxiliary contact indicates that manual bypass Q2 hasbeen closed.4564 DETOUR OFF The auxiliary contact indicates that manual bypass Q2 hasbeen opened.4567 COMMAND LOAD ON UTILITY The control unit received a command to transfer the loadon utility.4568 COMMAND LOAD ON INVERTER The control unit received a command to transfer the loadon inverter.4572 NO MORE OVERLOAD End of the overload condition previously detected withalarm 4570.4580 INVERTER AND UTILITYSYNCHRONIZEDThe voltages of inverter and utility bypass aresynchronized.4582 COMMAND NOTTO SYNCHRONIZECommand not to synchronize with utility has been done for:utility bypass out of tolerance (alarm 4410) or settingrespective parameters.4583 COMMAND TO SYNCHRONIZE Command to synchronize with utility has been done for:utility BP OK (4410) or setting respective parameters.4600 COMMAND UPS ONThe ECO Mode function has been disabled or theprogrammed time is expired.The UPS returns to VFI mode supplying the load normallyby inverter.4601 COMMAND UPS STANDBYThe function ECO Mode is enabled, and according to thetime program the UPS will run in ECO Mode, supplying theload normally by utility.4602 Q1 OPEN The auxiliary contact indicates that the output switch Q1has been opened.4603 Q1 CLOSED The auxiliary contact indicates that the output switch Q1has been closed.4699 BATTERY TEST IMPOSSIBLENot possible to start battery test (it is postponed) for:- No utility rectifier or bypass- Battery not fully charged- Load is below 10% or above 80%4763 REMOTE CONTROL ONInverter can be started or shutdown by remote control.Commands source can be chosen depending on the valueof respective parameter (password required):0 = Only local panel1 = Only Remote Control2 = Both4764 REMOTE CONTROL OFFInverter can be started or shutdown by remote control.Commands source can be chosen depending on the valueof respective parameter (password required):0 = Only local panel1 = Only Remote Control2 = Both