GE PFE28 Owner's Manual And Installation Instructions

Also see for Profile Series: Manual Quick Use & Care Owner's manual Owner's manual Installation instructions

GE PFE28 Owner's Manual And Installation Instructions Manual pdf 12 page image

12*Select Models OnlyAbout the GE® RPWFE water filter cartridge.Water Filter CartridgeThe water filter cartridge is located in the fresh food interioron the left side wall, near the top.This product uses radio frequency identification (RFID) todetect leaks and monitor filter status. The RFID technology iscertified by the FCC.When to replace the filter cartridgeThe filter cartridge should be replaced every six months orearlier if 170 gallons of water has been dispensed or the flow ofwater to the dispenser or icemaker decreases.Touch Screen Models: A filter status message will appear onthe screen when the water filter needs to be replaced. The filterstatus will automatically update when the filter is replaced.Non-touch Screen Models: A filter indicator light will illuminateon the screen when the water filter needs to be replaced.Removing the filter cartridgeTo replace the filter, first remove the old cartridge by openingthe filter door and pulling on the bottom of the cartridge to allowit to swing outward. When the cartridge can no longer swing,gently pull to unseat it from the cartridge holder. DO NOT TWISTCARTRIDGE. A small amount of water may drip out.Installing the Filter Cartridge1. Align top of filter cartridge with cartridge holder with the word“FRONT” facing outward then push the cartridge towardthe rear of the unit until it is fully seated. DO NOT TWIST THEFILTER CARTRIDGE!2. While continuing to ensure cartridge is fully seated in theholder, gently swing the filter inward until it is in position. Iffilter will not swing easily, check to ensure filter is properlyaligned and fully seated within the cartridge holder. Close thefilter door.3. Run two gallons of water through the cold water dispenser(about 5 minutes) to remove air from the system. A newlyinstalled filter cartridge will cause water to spurt from thedispenser. Use a large pitcher or sports bottle to catch thewater spray. DO NOT use hands-free auto-fill (some models)until all air is removed from the system.4. Reset Filter Status message (non-touch screen models).WARNING Scalding Hazard.*Use of the hot water dispenser prior to purging air from thesystem may result in spurting of hot water and lead to hot waterscalding. Follow the instructions above to purge all air from thesystem through the cold water dispenser prior to using the hotwater dispenser.Note: It is normal for water to appear discolored during the initialsystem flush. Water color will return to normal after first fewminutes of dispensing.Filter Bypass PlugTo reduce the risk of property damage due to water leakage,you MUST use the filter bypass plug when a replacement filtercartridge is not available. The dispenser and icemaker will notoperate without either the filter or bypass plug installed. Thebypass plug is installed in the same way as a filter cartridge.FCCID: ZKJ-EBX1532P001 ICID: 10229A-EBX1532P001“This device complies with part 15 of the FCC Rules. Operation issubject to the following two conditions: (1) This device may notcause harmful interference, and (2) this device must accept anyinterference received, including interference that may causeundesired operation.”“This device complies with Industry Canada licence-exemptRSS standard(s). Operation is subject to the following twoconditions: (1) this device may not cause interference, and (2)this device must accept any interference, including interferencethat may cause undesired operation of the device.”WARNINGTo reduce the risk associated with choking, do not allow children under 3 years of age to have access to small partsduring the installation of this product. The disposable filter cartridge should be replaced every 6 months at the rated capacity,or sooner if a noticeable reduction in flow rate occurs.For the maximum benefit of your filtration system, GE recommends the use of GE-branded filters only. Using GE-branded filtersin GE and Hotpoint® refrigerators provides optimal performance and reliability. GE filters meet rigorous industry NSF standardsfor safety and quality that are important for products that are filtering your water. GE has not qualified non-GE-branded filtersfor use in GE and Hotpoint refrigerators and there is no assurance that non-GE-branded filters meet GE’s standards for quality,performance and reliability.If you have questions, or to order additional filter cartridges, visit our website at www.geapplianceparts.com or call GEParts and Accessories, 800.626.2002.Customers in Canada should consult the yellow pages for the nearest Camco Service Center.SwingPush \ Pull