REINSTALLING THE REFRIGERATOR DOORSReverse steps 1 through 4 to reinstall refrigerator, followdetails below for critical alignments.A Reinstall center hinge first and torque the screws to 65in-lbs. With the LH door at 90º to the front ofthe case, lower the refrigerator door onto the center hinge.Ensure that the door and hinge align correctly.B Rotate doors closed and make sure moveable center sealingportion of the door aligns with the striker. If the door will notself-close after reinstalling, remove door, turn door upsidedown, check alignment mark and arrow; (there is analignment mark on the door closure mechanism. Itcorresponds to an alignment arrow on the plastic ring. Rotatedoor closure mechanism to align mark and arrow, reinstalldoor).Securely tape the door shut with masking tape or have asecond person support the door. Reinstall the top hinge andtorque the screws to 65 in-lbs.C Be sure to reinstall the ground wire and strain relief to the tophinge.D Reinstall hinge cover. NOTE: Ensure wires are not pinched orunder screw bosses before tightening screws.REMOVE THE REFRIGERATOR DOORS (cont)Note: for proper installation later, please follow the next stepcarefully.F Remove the tape and keeping the door asstraight as possible, open the door to 90º then liftstraight up to remove it.REMOVE OPPOSITE DOORFollow the same procedure on the opposite door. Thereare no wires or water lines on the opposite side4 REMOVE CENTER HINGE (if necessary)Remove the 3/8ļscrews securing the center hinge to thecabinet.Use T20 driver to remove outboard screw25Installation InstructionsINSTALLING THE REFRIGERATOR (cont.)5Loosen OuterscrewsRemovecenter screwLift up & offcenter hingeOpen Door to 90°Align flats with tab.Underside OFFresh Food DoorIf door cannot be installed at 90° follow steps below:1. Install door at 180° to case front.2. If space limits opening door to less than 180°, then:a) Remove door, carefully turn door upside down.b) Check alignment of door closure mechanism shaft onunderside of door. The flats on the shaft should correspondto alignment tab on plastic ring or mark on bottom end cap.c) If shaft is not aligned to tab/mark, using 5/32” Allen wrench,rotate door closure mechanism shaft counterclockwisefor right door and clockwise for left door. Then alignflat with tab/mark.d) Install the door at 90°.