GE Profile DPVH890EJ Technical Service Manual

Also see for Profile DPVH890EJ: Owner's manual and installation instructions Dimensions and installation information Installation information

– 14 –Note: The drum seal can be replaced by extractingthe seal from the channel located in the air ductassembly.3. Unhook the plastic tabs on each side of theair duct assembly and remove the air ductassembly.To remove the drum slide assembly:Remove the control, top, and front panels. (See1.Control Panel, Top Panel, and Front Panel.)Remove the air duct assembly. (See2. Air DuctAssembly.)Grasp the top of the drum slide assembly and3.pull down and inward to release the assemblyfrom the 2 tabs located at the top of the frontpanel.Support SlidesGuide Slide Guide SlideDrum Slide AssemblyThe drum slide assembly is located on the backside of the front panel and utilizes 4 drum slides.Two white outer slides are used as guides, and 2dark color center (top) slides are used to support theweight of the drum. When replacing the slides, thedark-colored support slides must be used to replacethe top support slides. Guide slides may also bereplaced with support slides.Caution: Do not replace the center (top) supportslides with the white guide slides. Damage to thedryer will result.Tab TabTab TabDrum SealAir Duct AssemblyThe air duct assembly houses the lint filter, drumseal, and the 2 sensor rods. It is located on the backside of the front panel.Note: The sensor rods are part of the air ductassembly. To replace the sensor rods, the air ductassembly must be replaced.To remove the air duct assembly:Remove the control, top, and front panels. (See1.Control Panel, Top Panel, and Front Panel.)Remove the 2 Phillips-head screws that attach2.the air duct assembly to the front panel.(Continued Next Page)