GE Profile DPVH890EJ Technical Service Manual

Also see for Profile DPVH890EJ: Owner's manual and installation instructions Dimensions and installation information Installation information

– 19 –4. Compress then remove the front and rear motorstraps from the motor baseplate.5. Move the dual idler pulley assembly to the left,then remove the drum motor from the motorbaseplate.6. Place the drum motor (pulley side up) on thedryer base plate, then disconnect the wireharness.Note: When installing the drum motor, ensure thetab on the motor coupling is engaged in the slot onthe motor baseplate before installing the front andrear motor straps.DisconnectMotor StrapTabSlotMotor StrapBlower MotorThe blower motor is a 120-VAC, 1/8-hp, 1.6-amprated motor. The tachometer at the back of themotor provides speed input to the main board.Motor resistance values:Start winding = approximately 5 ΩRun winding = approximately 4 ΩThe blower motor is attached to a plate that is heldto the blower housing with 5 Phillips head screwsand two tabs that engage 2 slots in the dryer floor.The blower wheel is held to the motor shaft by ablower wheel clamp. A vapor shield is installed overthe top of the blower housing.To remove the blower motor:Remove the drum. (See1. Drum.)Loosen the 3/8-in. hex-head screw that secures2.the blower wheel clamp to the motor shaft.Remove the 2 Phillips-head screws that attach3.the motor plate to the frame.Note the position of the vapor shield, then4.remove the top Phillips-head screw and thevapor shield.5. Remove the Phillips-head screw that attachesthe outlet control backup thermostat to theblower housing.(Continued Next Page)