GE Profile PDW8100 Series Installation Instructions Manual

Also see for Profile PDW8100 Series: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Installation Instructions10STEP 13 CONNECT WATER SUPPLYConnect water supply line to 90° elbow.• Slide compression nut, then ferrule over end ofwater line.• Insert water line into 90° elbow.• Slide ferrule against elbow and secure with compres-sion nut.IMPORTANT – Check to be surethat door spring does not rub or contact the fill hose orwater supply line. Test by opening and closing the door.Re-route the lines if a rubbing noise or interferenceoccurs.Figure CC• If a longer drain hose is required, add up to 42" oflength for a total of 10 ft. to the factory installed hose.Use 5/8" or 7/8" inside diameter hose and a coupler toconnect the two hose ends. Secure the connectionwith hose clamps.Figure DDSTEP 14 CONNECT DRAIN LINEFOLLOW ALL LOCAL CODES AND ORDINANCES.The drain hose molded end will fit 5/8", 3/4" or 1"diameter connections on the air gap, waste tee ordisposer. Cut on the marked line as required for yourinstallation.DRAIN LINE INSTALLATION• Connect drain line to air gap, waste tee or disposerusing either previously determined method.Waste Tee InstallationMethod 1 – Air gap with waste tee or disposerDisposer InstallationWaste Tee InstallationMethod 2 – Built-in “High drain loop” with waste tee ordisposerDisposer InstallationFigure FFFigure GG• Secure the drain hose to the air gap, waste tee ordisposer with clamps.NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED10 FEET FOR PROPER DRAIN OPERATION.IMPORTANT –When connecting drain line todisposer, check to be sure that drainplug has been removed. DISH-WASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.TIP: Avoid unnecessary service call charges. Always besure disposer drain plug has been removed beforeattaching dishwasher drain hose to the disposer.Figure EECutting Lines1" 3/4" 5/8"IMPORTANT: Do not cut corrugatedportion of hose18"Min. 18"Min.90° ElbowFerrule90° ElbowHot WaterSupply LineCompression NutDoor SpringRemoveHopperPlugHose ClampCoupler Hose Clamp