Installation Instructions• Align the toekick with the bottom edge and makesure it is against the floor.• Insert and tighten the two toekick attachmentscrews. The toekick should stay in contact with thefloor.TIP: Make sure toekick is against floor to minimizenoise.Figure JJSTEP 19 LITERATURE• Be sure to leave complete literature package andinstallation instructions with the consumer.STEP 18 REPLACE TOEKICK• Place toekick against the legs of the dishwasher.STEP 17 DISHWASHER WET TEST Turn on power supply (or plug power cord intooutlet, if equipped). Start the unit to check for leaks.PDW8100-PDW8800 Series:– Latch door– Push RINSE ONLY pad– Push START/RESET padPDW9200-PDW9800 Series:– Push RINSE ONLY pad– Push START/RESET pad– Close door Push “Rinse Only” button. Push start/reset pad once. Check to be sure that water enters the dishwasher.If water does not enter the dishwasher, check to besure that water and power are turned on. Check for leaks under the dishwasher. If a leak isfound, turn power supply off, then tighten connec-tions. Restore power after leak is corrected. Check for leaks around the door. A leak around thedoor could be caused by door rubbing or hittingagainst adjacent cabinetry. Reposition the dish-washer if necessary. See Step 12. The dishwasher will drain and turn off about 5minutes after it was started. Check drain lines. Ifleaks are found, turn power off at the breaker andcorrect plumbing as necessary. Restore powerafter corrections are made. See Step 14. Open dishwasher door and make sure most of thewater has drained. If not, check that disposer plughas been removed and/or air gap is not plugged.See Step 14. Also check drain line for kinking. Run the dishwasher through another “Rinse Only”cycle. Check for leaks and correct if required.ToekickAttachment ScrewsPub. No. 31-30561Dwg. No. 206C1559P101(N.D. 756) 6/03–Rev.SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE