GE Profile PDW8100 Series Installation Instructions Manual

Also see for Profile PDW8100 Series: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

Installation Instructions6• Do not over tighten 90° elbow, water valve bracketcould bend or water valve fitting could break.• Position the end of the elbow to face the rear of thedishwasher.STEP 5 INSTALL 90° ELBOW• Wrap 90° elbow with thread seal tape.• Install a 90° elbow onto the water valve.Figure MFigure KSTEP 3 REMOVE TOEKICK• Remove the two toekick screws.• Screw leveling legs back into the dishwasherframe, approximately 1/4" from frame as shown.Figure JSTEP 2 REMOVE WOOD BASE,INSTALL LEVELING LEGSIMPORTANT – Do not kick offwood base! Damage will occur.• Move the dishwasher close to the installationlocation and lay it on its back.• Remove the four leveling legs on the underside ofthe wood base with an adjustablewrench or 15/16" socket.• Discard base.Approx.3/4"ToekickRemove 2Toekick Screws• Connect incoming power cord white (or ribbed) todishwasher white, black (or smooth) to black andground to dishwasher green wire. Use UL listedwire nuts of appropriate size.• Replace junction box cover. Be sure wires are notpinched under the cover.STEP 4 INSTALL POWER CORDSkip this step if dishwasher will be direct wired orhas a factory installed power cord.The power cord and connections must comply withthe National Electrical Code, Section 422 and/or localcodes and ordinances.• Maximum power cord length is 6 feet.Figure LFront of Dishwasher90°ElbowThreadSeal TapeFillHoseWater ValveBracketWhiteGround BlackCheck That White, Black andGreen Dishwasher Wires Are ThreadedThru Small Hole in BracketRemoveJunction BoxCoverInsert PowerCord Wires ThruStrain Reliefand TightenUse UL ListedWire NutsACBD