Garland S680 SERIES Installation And Service Manual

Also see for S680 SERIES: Installation and operation manual Installation, operating and service instructions Installation and operation manual

Contents

Garland S680 SERIES Installation And Service Manual Manual pdf 12 page image

Part # P152 Rev 1 (01/13/10)Page 12Miscellaneous1 Grease the door hinges and check for loose fastenersTighten as necessary2 Wire brush the surface of the griddle to remove bakedon material, wash with hot water, dry thoroughly Lightlycoat the surface with vegetable oil to prevent rustingMAINTENANCE AND CLEANING continued3 Wipe exposed cleanable surfaces with a mild detergentand hot water Stubborn residue may be removed witha light weight non-metallic scouring pad Stainless steelareas should be washed with a mild detergent, hot waterand a soft cloth If necessary use a nonmetallic scouringpad always rub in the of the grain in the metal to preventscratching NEVER USE STEEL WOOL4 Clean the oven racks shelves and guides with hot soapywater and dry thoroughly Clean the oven interior with apropriety oven cleaner following instructionsREPLACEMENT OF PARTSServicing must be carried out by competent persons inaccordance with the lawWARNING: Turn off the electrical mains before commencingany servicing workDoor Switch1 Drop the lower kick panel2 Remove the screws securing the door switch andmounting brackets and remove screws securing the doorswitch3 Remove the terminal cover and disconnect the wiresfrom the terminals on the body of the switch4 Replace the faulty door switch5 Make certain that the newly installed door switch isproperly adjusted so as the interrupt the power supplyto the control system and fan motor when the door isopenedFan Cook/Cool Down Switch1 Remove the screws securing the front panel to the frontrail and drop the panel2 Disconnect the wires from the terminals on the switch3 Depress the tabs of the switch body and push the switchthrough the opening in the control panel4 Replace the switch and reassemble in reverse orderThermostat1 Remove the screws securing the front panel to the frontrail and drop the panel2 Disconnect the wires from the taps on the thermostat3 Remove the dial from the thermostat and the screwssecuring the thermostat body to the control panel4 Remove the wires from the thermostat terminals Be sureto note which wire connects to which terminal on thethermostat5 Remove the thermostat bulb6 Replace the faulty thermostat and reassemble in reverseorderHeat On Lamp1 Remove the screws securing the front panel to the frontrail and drop the panel2 Disconnect the supply wires to the lamp and remove thefaulty lamp3 Reassemble in the reverse order