Garland XE24 Installation, Operating & Service Instructions

Also see for XE24: Installation, operation and maintenance manual Installation and operation manual

Part # 4517125 (09/03)Page 14CLEANING AND MAINTENANCE continued7. Remove the release sheet locking clips and bars.8. Scrape only the lower grill surface with a grillscraper, and squeegee any residue into the greasetroughs with a grill squeegee.Caution: Do not scrape or otherwise scratch theupper platens. The use of metal scrapers, abrasivepads, or wire brushes will permanently damagethe surface of the upper platens.9. Open one packet of high-temperature grill cleaner,(several cleaners may be available on the market),and empty the contents into a suitable container.(One packet will clean one grill.)10. Firmly attach a no-scratch pad to a pad holder.11. Dip the no-scratch pad into the grill cleaner, andspread a light coating of grill cleaner over the entireplaten surface, back, front, and side edges of bothupper platens. DO NOT SCRUB.12. After applying the grill cleaner, lightly scrub theplaten surfaces, BACK, FRONT AND SIDEEDGES with the no-scratch pad until all the soilhas been liquefied by the grill cleaner. For stubbornsoils, apply additional grill cleaner and lightlyscrub. DO NOT RINSE THE PLATENS ATTHIS TIME.13. Starting at the back of the lower grill, spread a lightcoating of grill cleaner over the entire surface. DONOT SCRUB.14. After applying the grill cleaner, lightly scrub thegrill surface with the No-Scratch Pad until all thesoil has been liquefied.15. Rinse the upper platens with a dripping wet cloth.16. Carefully pour small quantities of lukewarmwater onto the grill while brushing the surface,backsplash, and bullnose with a pot brush orequivalent high-temperature brush. Continue untilthe water no longer boils away and the grill remainswet. Squeegee dry.Caution: Ice, cold water, or large quantities of watermust never be applied to the grill plate or upper platen.Severe damage to the grill will occur!17. Clean the release sheets as follows:A) Place the sheets on the lower grill. Scrub bothsides of the sheets with the same no-scratchpad used on the grill.B) Rinse both sides of the sheets with a clean, wetcloth.18. Rinse the lower grill by flooding the surface twicewith lukewarm water. Squeegee after each rinse.19. Wipe the lower grill surface, backsplash, bullnose,and hood with a clean, damp cloth.20. When cleaning is completed, you may turn the“MASTER POWER” (rocker) switch off.AFTER CLEANING, apply a thin coat of freshshortening to the lower grill surface only. Wipedown the surrounding areas. Empty, wash, rinse,and replace the grease troughs.Platen Zeroing:Turn Master power switch “ON”, wait for controllersto display “OFF”.1. Press and hold for three, (3) seconds. “ENTERCODE” will be displayed.2. Using the Gap Setting buttons,enter the code, (1251). “ENTER CODE **** ” willbe displayed.3. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS”will be displayed.4. Press two, (2) times in succession to display“PROGRAMMING MODE SYSTEM SETUP.”5. Press six, (6) times. “PLATEN SET +/- XX” willbe displayed. (XX=numbers that will vary fromgrill to grill.)