Garland XE24 Installation, Operating & Service Instructions

Also see for XE24: Installation, operation and maintenance manual Installation and operation manual

Part # 4517125 (09/03)Page 26CALIBRATIONBi-Weekly Calibration:Tools: Digital Pyrometer with Surface ProbeWarning: PERSONAL INJURY FROM BURNS MAYRESULT WHEN COMING IN CONTACT WITHHOT COOKING SURFACES.NOTE: Calibration of grills is done with releasematerial sheets installed.NOTE: CALIBRATION REQUIREMENTSThe control software will beep to the user when itis appropriate to calibrate. The control will allowcalibration provided the following conditions aremet:• Temperature is currently falling from a detectedpeak of 360°F or higher.• Temperature is falling and has fallen 2°F from adetected peak that is within the 350-360°F range.(i.e. calibration would be allowed at 355°F if theachieved peak temperature was 357°F)• Temperature is rising through the 350-360°Frange as a result of a heat on pulse of less than 30seconds.To Calibrate:1. The upper platens and lower grill plate should be atoperating temperatures to perform this calibrationprocedure.Turn on the Master Switch and press to entercooking mode.2. Press or to select a “CLAM” operation andallow the grill to reach the set temperature andstabilize, (approximately 30 minutes).3. Press and hold for three, (3) seconds. “ENTERCODE” will be displayed.4. Using the Gap Setting buttons,enter the code, (1251). “ENTER CODE **** ” willbe displayed.5. Press to enter the Programming Mode.“PROGRAMMING MODE MENU ITEMS”will be displayed.6. Press two, (2) times. “PROGRAMMINGMODE SYSTEM SETUP” is displayed.7. Press four, (4) times. “PROBE CAL – UPPERXXXF” will be displayed.8. Place the surface probe of the digital pyrometerdirectly on the probe location, (see diagram onfollowing page).9. Allow at least 5 seconds for the pyrometer torespond and stabilize. Note the temperature on thepyrometer.10. If the temperature on the grill control display doesnot match the temperature on the pyrometer, adjustthe temperature on the grill control accordinglyusing the and buttons.11. Press . “PROBE CAL – GRILL XXXF” will bedisplayed.12. Repeat steps 8 - 10.13. Press to save the changes.14. Press to return to “PROGRAMMING MODESYSTEM SETUP”15. Press again to exit.16. Repeat steps 1 - 15 at each control.