Garland XE24 Installation, Operating & Service Instructions

Also see for XE24: Installation, operation and maintenance manual Installation and operation manual

Part # 4517125 (09/03)Page 8GRILL CONTROLSMaster Power Switch:Controls power to the grill and must be turned “ON”to start operation. The controller display will be activewhen the switch is “ON”.Indicator Lights:There are two, (2), indicator lights, indicating thetemperature status of each control’s heat zones; one,(1), on the upper platen, (top light), and one, (1), onthe grill surface. Each light can display three, (3),different colors, indicating temperature status for thecorresponding zone.Red: The zone is too hot, (more than 79°F/45°C overthe set temperature), or heat zone failure.Amber: The zone is calling for heat.Green: The zone is at or above the set temperature.Display:The controller display will contain information relevantto each operation in both cook and program modes.Gap Setting Buttons (1-5):For two-sided recipes, the desired gap button is pressedbefore the cook cycle begins to set the gap. Hold buttons1-5 to apply gap settings 6-10. The chosen gap buttonand its value will be displayed. Until a different menuitem is selected, (or the current item is changed and thenreturned to), the Gap Button only needs to be pressedbefore the initial cook.Gap Button:When in programming mode, press the Gap Button toset the values for Gap Buttons 1-10. Press Enter to acceptthe changes. After going through all ten, you will returnto Programming Mode.GAPSETTINGBUTTONSGAPBUTTONDISPLAYREADYINDICATORSWHEN PUSHED SIMULTANEOUSLY:"START COOK TIME COUNTDOWN" (flat grill cooking)OR "LOWER PLATEN" (two-sided cooking)POWERBUTTONMASTERPOWERSWITCHONOFFENTERBUTTONPROGRAMBUTTONDOWN ARROWBUTTONTEMPERATUREBUTTONUP ARROWBUTTONCANCEL/RAISE PLATENBUTTON