Garmin APOLLO GX SERIES Service Manual

Contents

© 2004 Garmin AT GX Service Manual 5-1Chapter 5. Aircraft Installation TroubleshootingReducing the effects of VHF Interference on GPS InstallationsWhy do we test for VHF interference?Checking for VHF harmonic interference is a requirement called out in the FAA Advisory Circular AC20-138. The Advisory Circular requires VHF interference checks along with other requirementsneeded to gain approval. The GPS signals are transmitted from satellites that are in orbit 10,000miles above the earth. By the time these signals reach the earth they are weak, buried in noise, andeasily swamped by an interference source. As GPS receivers are susceptible to VHF harmonics andother interference on the L1 GPS frequency, all GPS receivers approved for use in instrumentconditions must have the VHF interference tests performed.There are new FAA changes to AC 20-138 that will expose more VHF interference problems than youhave experienced in the past. These changes will require the shops to test each interfering frequencyfor a period of 45 seconds. The current requirement calls for a 20-second transmit test. The changesare intended to identify all interference sources to insure reliable GPS performance in IFR conditions.Some GPS manufactures have masked VHF interference problems through software techniques likecoasting, and not warning the pilot during temporary signal outages. Coasting is a method for dealingwith momentary outages, but the TSO also requires the GPS receiver to warn pilots within 10seconds of a signal loss during approach operations. All UPS Aviation Technologies GPS productswill warn the pilot within 10 seconds per the TSO requirements. It is important to isolate potential VHFinterference sources, and eliminate them.The Advisory Circular states, “Remove any source of VHF interference from the aircraft.” We havelisted some steps that can be taken to reduce the effects of interference. The intent here is to saveyou time and money on GPS installations. The following provides some practical steps to help youidentify and minimize GPS interference sources on board aircraft.What can we do to minimize VHF interference?Perform a pre-installation check to determine if there is going to be a problem with VHF interference.Ninety percent of the time when our tech support phone rings with one of these VHF problems, wehear, “The equipment is installed, antenna bolted down. I’ve tried everything. Can you help?” Werecommend that you perform a pre-installation checkout that will help determine if there is a VHFinterference problem.Pre-Installation CheckoutTake a few minutes with the aircraft before completing the installation quote to your customer. Youcan get a good idea if you need to add a few extra hours to the quote by using a handheld GPS, or,better yet, a spectrum analyzer. A spectrum analyzer is the preferred tool, if available. When using aportable GPS, which is available to most shops, turn it on and observe the signal strength display. Forexample, the Apollo Precedus shows signal strength for up to eight satellites. Obtain some averageGPS signal strength readings as you walk around the aircraft. Key up Comm 1 on the entire list ofVHF frequencies listed in the Advisory Circular. Observe the effects of VHF transmissions on thesignal strength display of the portable GPS unit. Repeat the test for Comm 2. During the interferencechecks, make sure you get the portable GPS antenna as close as you can to the VHF Commantennas, the ELT antenna, and the direction-finding antenna. This procedure should also help indetermining the best location for the GPS antenna. Check the interference levels at different top-mounted locations using the portable GPS antenna. If the interference is too strong, causing a loss ofGPS signals in all possible antenna locations, follow the suppression guidelines below. You should