9 - AUX PAGES177190-00356-00 Rev GSetup 24. Turn the large right knob to highlight theright (decimal) part of the frequency field.5. Turn the small right knob to enter the desiredfrequency.6. Repeat for any remaining desired frequencies,then press the small right knob to finish.When the remote Com frequency recall switch ispressed, the next preset frequency will be moved intothe Com Standby frequency box and a small windowwith the current Com Frequency Preset number willappear next to it. You can scroll down through the presetfrequencies by repeatedly pressing the remote Com Fre-quency recall switch. Empty Preset slots are skipped.DisplayTo change the backlighting intensity:1. Select “Display” from the Setup 2 page.2. The flashing cursor highlights the backlightmode field. Turn the small right knob to selectthe desired mode: Auto or Manual. Press ENTto accept the selection.3. If “Manual” is selected, the flashing cursormoves to the backlight level field. Turn thesmall right knob to select the desired level.Press ENT to accept the selection.To change the display contrast:Contrast setting is adjustable in either Auto orManual Mode. Auto mode is the preferred setting. Thecontrast value edited in Auto Mode is not the actualcontrast, but an offset that is applied to the automaticvalue generated by the formula based on unit tempera-ture.1. Select “Display” from the Setup 2 page.2. Turn the large right knob to highlight thecontrast mode field.3. Turn the small right knob to select the desiredmode: Auto or Manual. Press ENT to acceptthe selection.4. The flashing cursor moves to the contrast levelfield. Turn the small right knob to select thedesired level. Press ENT to accept the selec-tion.
