Garmin GPSMAP 2106, 2110 Owner's Manual

Also see for GPSMAP 2106 - Marine GPS Receiver: Quick reference guide Install guide Installation instructions

Contents

Garmin GPSMAP 2106, 2110 Owner's Manual Manual pdf 14 page image

6 GPSMAP 2106/2110 Owner’s ManualGETTING STARTED > INITIALIZING THE GPS RECEIVERReceiver Status and AccuracyThe Status field on the Info sub tab shows the receiver status. Current accuracyis shown in the EPE (Estimated Position Error) field. Accuracy uses the numberof received GPS satellites, signal strength, and satellite orientation, to calculatelocation accuracy in feet or meters. The Status field shows one of the followingconditions:• Searching for Satellites—the receiver is looking for any satellites andcollecting data from satellites visible at its last known or initializedlocation, but has not collected enough data to calculate a fix. This processcan take up to five minutes.• Ready For Navigation—at least three satellites with good geometrywere acquired, and your location is now being calculated in latitudeand longitude; or at least four satellites were acquired and your locationis being calculated in latitude, longitude, and elevation. “Ready ForNavigation with WAAS” appears when you are receiving WAAS satellitecorrections in 2D or 3D, and a D appears on the strength bar of satellitesbeing corrected.After the receiver has collected information from at least three satellites, theStatus field shows either “Ready for Navigation” or “Ready for Navigation withWAAS.” The GPSMAP 2106/2110 is now ready for use. Press QUIT to return tothe Map Page.GPS SetupThe Setup sub tab provides access to functions and features relating to initializingthe GPS receiver.To access the GPS Setup sub tab:1. Press and hold ADJ/MENU to open the Main Menu.2. Highlight the GPS tab, and then highlight the Setup sub tab.Setup Sub TabThe Setup sub tab contains the following options:Skyview Orientation—allows you to select a sky view orientation, either NorthUp or Track Up, for the GPS Info sub tab only.Source—set to Garmin when using a Garmin sensor (GPS 17); set to NMEAwhen using any other GPS NMEA source.WAAS—turns WAAS on or off.The following soft keys are active only when the unit is not receiving satellitesand the Source is not set to Garmin:• AutoLocate—allows the receiver to find your location automatically. Thisprocess can take up to five minutes.• Set Position—allows you to initialize the receiver from the Map Page toinitially help the receiver acquire satellites more quickly.