Garmin Rino 110 Owner's Manual And Reference Manual

Also see for RINO 110 - Hiking GPS Receiver: Technical spesification Features Specification Quick start guide Owner's manual

Contents

Garmin Rino 110 Owner's Manual And Reference Manual Manual pdf 16 page image

6which channels/codes to scan. Since it can take time toscan through the all the channels, selecting only specificchannels/codes will decrease the scan time. Decreasing scantime will help prevent the chances of missing a transmis-sion. The Scanlist also has Option Menu choices to ‘ScanCurrent Codes’ or ‘Scan All Codes’. Choosing ‘Scan CurrentCodes’ will scan only the Channel and Code combinationin memoryThe ‘Monitor’ option lets you listen to a single channelfor any activity, including static and weak voice signals.The Rino series will automatically squelch a frequency tofi lter out unwanted noise. Using the Monitor option willtemporarily turn off the automatic squelch allowing youto hear the open channel. If you see a broken transmissionsymbol (see pg. 9), you may be receiving a signal too weakto trigger the unit’s squelch. You might choose this optionif a signal is getting out of range or weak.To Scan or Monitor a channel(s):1. Using the THUMB STICK, highlight the ‘Scan’ or‘Monitor’ button and then press the THUMB STICKkey IN. ‘Scan’ will start searching through the avail-able channels. ‘Monitor’ will open the channel inorder to listen to any radio transmissions on thatchannel.2. To stop using either option, highlight the button withthe THUMB STICK and press IN.To Setup a Scanlist:1. Using the THUMB STICK, highlight the OptionsMenu on-screen button and press IN. Highlight ‘SetupScanlist’ and press IN on the THUMB STICK.2. To add/remove a channel from the list, highlightthe channel and press IN on the THUMB STICK toadd/remove the check mark in front of the name.Only channels that are checked will be scanned.3. To Select/Clear All channels, highlight either the‘Select All’ or ‘Clear All’ buttons and press IN on theTHUMB STICK.4. To ‘Scan All Codes’ or ‘Scan Current Codes’, highlightthe Options Menu and press IN on the THUMBSTICK. Choose the desired setting and press IN onthe THUMB STICK.Radio PageScan & MonitorThe Code field will goblank when you monitora channel.Scanlist Options.