Genie 2022 Manual

Also see for 2022: User manual Installation manual

Contents

PN# 37026500123 05/15/2009163. Securely fasten wires.• Securely fasten wires to ceiling andwall using insulated staples provided.– Use insulated staples.– Staples should be snug only.• If rear cover is attached to power head,remove it.• On power head:– Route Wall Control wires through wire guideon power head.– Split and strip ends of wire (Fig. 3-2 onprevious page).– Insert wire into terminal holes and lightly press inthe orange locking clips above each terminalhole. (You can use a pencil or small screwdriverto comfortably press in locking clips.) The whitewire into #1 terminal hole and striped wire intothe #2 terminal hole.– Confirm wire lock by lightly tugging on the wire.The wire should remain in the terminal hole.• Do NOT install rear cover yet.4. Mounting.• Fasten Wall Control to wall with 2 screws(provided) (Fig. 3-4).• Remove protective backing from "Entrapment"warning label (Fig. 3-5). The "Entrapment" labelis located in the center of this manual.– Stick label on wall near Wall Control.FIG. 3-4 Mounting Wall Control.Child can be pinned under automatic garage door.Death or serious injury can result.• Never let child walk or run under moving door..• Never let child use door opener controls.• Always keep moving door in sight.• If person is pinned, push control button or useemergency release.• Test door opener monthly:Refer to your owner'’s manual.Place 11/ 2 -inch object (or 2x4 laid flat) on floor.If door fails to reverse on contact, adjust opener.If opener still fails to reverse door, repair or replace opener.Do not remove or paint over this label.Mount wall control out of child's reach (at least 5 feet above floor).Place next to wall control.©1999InsulatedStaple+ –P BInfaredSensor123456FIG. 3-3 Insert wires.(Power Head With Rear Cover Removed)1234TerminalHolesLockingClips56FIG. 3-5 Mounting Entrapment warning label.321Independent Light Control– Controls door opener lights from inside garage– Energy-Saver shut-off turns OFF lights 3 minutes afterdoor activationVacation Locking Switch– LOCK disables controls afterdoor is completely closed– UNLOCK allows controls towork normallyDoor Control "Open/Close" Button– Open and closes door frominside garagewire guide