Genie 2022 Manual

Also see for 2022: User manual Installation manual

Contents

PN# 37026500123 05/15/2009 23FCC and IC CERTIFIEDFIG. 7-1 Learn code button and LEDSETSETOPENFORCECLOSECODELEARN LIMITMANUALOpenTravel LimitOpenSet LimitButtonCloseTravel LimitCloseSet LimitButtonDown ForceControlAdjustmentUp ForceControlAdjustmentLearnCodeButtonLEDIndicator LightToGarage DoorThis device complies with FCC Part 15 and RSS 210of Industry Canada. This equipment has been testedand found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonableprotection against harmful interference in a residentialinstallation. This equipment generates, uses and canradiate radio frequency energy and, if not installedand used in accordance with the instructions, maycause harmful interference to radio communications.However, there is no guarantee that interference willnot occur in a particular installation. If this equipmentdoes cause harmful interference to radio or televisionreception, which may be determined by turning theequipment OFF and ON, the user is encouraged totry to correct the interference by one or more of thefollowing measures:• Re-orient or relocate the receiver antenna.• Increase the separation between the openerand receiver.• Connect the opener into an outlet on a circuitdifferent from that to which the receiver isconnected.• Consult your local dealer.PROGRAMMING REMOTE CONTROLS7NOTE: For remote control locate Box 3.1a. Single Button Remote Programming.NOTE: This opener can learn up to 7 transmitterbuttons.• Locate "Learn Code" button and indicatorLED on the power head (Fig. 7-1).• Press and release "Learn Code" button.– Indicator LED will blink RED at a rate of twiceper second.• Within 30 seconds, push remote controlbutton once.– Indicator LED will stop blinking and stay ON.• Press remote control button again.– Red LED will go out. Remote is now programmedand ready for use.1b. Multi Button Remote Programming.NOTE: Each button on a multi-button remote isdesigned for use with 1 door. You cannotprogram 2 buttons to operate the same door, norcan you program 1 button to operate 2 doors.You can program a maximum of 7 differenttransmitters or wireless devices.NOTE: Pushing two buttons on power headsimultaneously will erase programmed memory andlimits must be reset.• For each button .– Program each button separately using theSingle Button Remote Programming steps.2. Operating.• Press remote button once.– Door will move.• Press button again.– Door will stop.• Press button again.– Door will move in opposite direction.NOTE: The door will stop automatically at thefully open or fully closed position.CODELEARNA moving door can cause serious injury or death.1. Keep people clear of opening while door ismoving.2. Do NOT allow children to play with opener,including Wall Control, remote control, orWireless Keypad.3. During programming, the door opener couldbegin to run, so keep people and objects awayfrom the moving door and its parts. To keep thedoor from moving, close the door anddisconnect it from the Opener by pulling theEmergency Release.WARNINGLOST OR STOLEN REMOTE1. Clear memory.• Press and hold "Learn Code" button (onpower head) for 10 seconds or until the redblinking indicator LED goes out.• Program remaining or new remote controls asdone previously. Your door opener will nolonger recognize any signal received from themissing remote control, or any other which hasnot been reprogrammed.CODELEARNNOTE: To program aHomelink® and Car2U®device follow the Homelink® or Car2U®instructions in your car owner’s manual.Limit controls locationon power head.