7 - 2 DPL-25S • DPL-30S • DPL-35S Super Series Part No. 40462September 2016Section 7 - Repair Procedures1-2Base ComponentsHow to Adjust the PlatformManual Lowering Cable1 Remove the base-end covers to access theplatform manual lowering cable.2 Check to be sure:Steer handle end:• Actuator bracket is connected to the baseand the manual lowering valve• Manual lowering cable is connected to thebase with two lock nuts• Manual lowering cable is attached to theactuator bracketLadder end:• Actuator bracket is connected to the baseand the manual lowering valve• Manual lowering threaded rod is attachedto the actuator bracket3 Adjust the manual lowering lever. Adjust thecable and the threaded rod at the lever. Be sureto maintain equal tension on the cable andthreaded rod.Do not over-tighten the platformmanual lowering cable. Theplatform may not raise if there is tomuch tension on the cable.Base Assembly1-1InterlocksThe interlock contact brackets indicate properinstallation of the outriggers and only allow themachine to operate when the outriggers areproperly installed and adjusted.How to Remove an InterlockContact Bracket1 Fully lower the platform, turn the machine offand remove the key.2 Store the outriggers in the storage sockets.3 Trace the interlock contact bracket wires intothe junction box.4 Label and disconnect the contact bracket wires.5 Remove the interlock contact bracket mountingfasteners from the outrigger base socket.6 Grasp the interlock contact bracket inside thebase outrigger socket and pull it out with thewires.
