Genie Z-60/34 Operator's Manual

Also see for Z-60/34: Operator's manual Operator's manual Operator's manual supplement Operator's manual Service manual

Contents

Genie Z-60/34 Operator's Manual Manual pdf 27 page image

Part No. 82315 Genie Z-60/34 25Operator's ManualFourth Edition · First PrintingStarting the Engine1 At the ground controls, turn the key switch tothe desired position.2 Be sure both the ground and platform controlred Emergency Stop buttons are pulled out tothe on position.3 Gasoline/LPG models: Choose fuel by movingthe fuel select switch to the desired position.4 Move the engine start toggleswitch to either side. If the enginefails to start or dies, the restartdelay will disable the start switchfor 3 seconds.If the engine fails to start after 15 seconds ofcranking, determine the cause and repair anymalfunction. Wait 60 seconds before trying to startagain.All models: In extreme cold conditions, 20°F(-6°C) and below, warm the engine for 5 minutes toprevent hydraulic system damage.Emergency StopPush in either the ground or platform redEmergency Stop button to the off position to stopall functions and turn the engine off.Repair any function that operates when the redEmergency Stop button is pushed in.Selecting and operating the ground controls willoverride the platform red Emergency Stop button.Auxiliary ControlsUse auxiliary power only if the primary powersource (engine) fails.1 Turn the key switch to ground or platformcontrol.2 Pull out the red Emergency Stop button to theon position.3 Press down the foot switch when operating theauxiliary controls from the platform.4 Simultaneously hold the auxiliary power switchon and activate the desired function.The drive function will not operate with auxiliarypower.Operation from Ground1 Turn the key switch to ground control.2 Pull out the red Emergency Stop button tothe on position.3 Start the engine.To Position Platform1 Hold the function enable switch to either side.2 Move the appropriate toggle switch according tothe markings on the control panel.Drive and steer functions are not available from theground controls.Machines equipped with Platform Level ControlDisable Function: The platform level toggle switchwill not operate when the primary boom is raised orextended or the secondary boom is raised past thedrive speed limit switches.OPERATING INSTRUCTIONS