Regulatory Information B-7On the Use of the RF DeviceNOTE: The information in this section applies to models with the wirelessLAN module.USA and Canada Safety Requirements andNoticesIMPORTANT NOTE: To comply with FCC RF exposure compliancerequirements, the antenna used for this transmitter must be installed toprovide a separation distance of at least 20 cm from all persons and must notbe co-located or operating in conjunction with any other antenna ortransmitter.Radio Frequency Interference Requirements and SARThe FCC with its action in ET Docket 93-62 has adopted a safety standard forhuman exposure to Radio Frequency (RF) electromagnetic energy emitted byFCC certified equipment. The wireless LAN module meets the HumanExposure limits found in OET Bulletin 65, 2001, and ANSI/IEEE C95.1, 1992.Proper operation of this radio according to the instructions found in thismanual will result in exposure substantially below the FCC’s recommendedlimits. The following safety precautions should be observed: Do not touch or move antenna while the unit is transmitting orreceiving. Do not hold any component containing the radio such that the antennais very close or touching any exposed parts of the body, especially theface or eyes, while transmitting. Do not operate the radio or attempt to transmit data unless the antennais connected; if not, the radio may be damaged.Use in specific environments: The use of wireless devices in hazardous locations is limited by theconstraints posed by the safety directors of such environments.
