H3C MSR 20-1X Installation Manual

Also see for MSR 20-1X: Configuration guide Quick start

Contents

H3C MSR 20-1X Installation Manual Manual pdf 27 page image

20Figure 15 Wall-mounting170 mmStep4 Align the installation holes at the bottom of the router with two screws and hang the router on the screws.CAUTION:When mounting the router, keep the network interface facing downwards and the two sides withventilation holes vertical to the ground.Installing Generic ModulesFor the procedure for installing generic modules, including various smart interface cards (SICs), refer toMSR Series Routers Interface Module Manual.Connecting the PGND CableWARNING!Correctly connecting the protection grounding (PGND) cable is crucial to the lightning protection andelectromagnetic susceptibility (EMS) of your router. You must correctly connect the PGND cable wheninstalling or using the router.The power input end of the router is equipped with a noise filter. The neutral ground of the power inputend is directly connected to the chassis and called PGND (also known as chassis ground). The PGNDmust be well grounded so that induced current and leakage current can be safely led to the ground andthe EMS of the router can be reduced. The PGND cable can also protect the router against high lightningvoltage resulting from external network lines such as E1/T1 line or ISDN/PSTN line.The protection grounding terminal marked with a grounding label is located on the rear panel of thechassis, as shown in the following figure: