1-8#user-interface aux 0user-interface vty 0 4authentication-mode noneuser privilege level 3#returnThe configuration information output above in turn is the system configuration, logical interfaceconfiguration, physical port configuration, and user interface configuration.display startupSyntaxdisplay startup [ unit unit-id ]ViewAny viewParametersunit unit-id: Specifies the unit ID of a switch. It only can be 1.DescriptionUse the display startup command to display the startup configuration of a switch.Related commands: startup saved-configuration.Examples# Display the startup configuration file information of the current switch. display startupUNIT1:Current Startup saved-configuration file: flash:/config.cfgNext main startup saved-configuration file: flash:/config.cfgNext backup startup saved-configuration file: flash:/backup.cfgBootrom-access enable state: enabledTable 1-2 Description on the fields of the display startup commandField DescriptionCurrent Startupsaved-configuration file The configuration file used for the current startupNext main startupsaved-configuration file The main configuration file used for the next startupNext backup startupsaved-configuration file The backup configuration file used for the next startupBootrom-access enable stateWhether you can use the user-defined password to access the Boot ROM:z enabled indicates you can access the Boot ROM with the user-definedpassword.z disabled indicates you cannot access the Boot ROM with theuser-defined password.For related information, refer to the startup bootrom-access enablecommand in the File System Management part of the manual.
