1-13Displaying and Maintaining LLDPTo do… Use the command… RemarksDisplay the global LLDPinformation or the informationcontained in the LLDP TLVs tobe sent through a portdisplay lldp local-information [ global |interface interface-typeinterface-number ]Available in any viewDisplay the informationcontained in the LLDP TLVssent from neighboring devicesdisplay lldp neighbor-information[ brief | interface interface-typeinterface-number [ brief ] | list[ system-name system-name ] ]Available in any viewDisplay LLDP statisticsdisplay lldp statistics [ global |interface interface-typeinterface-number ]Available in any viewDisplay LLDP status of a port display lldp status [ interfaceinterface-type interface-number ] Available in any viewDisplay types of advertisableoptional LLDP TLVsdisplay lldp tlv-config [ interfaceinterface-type interface-number ] Available in any viewLLDP Configuration ExamplesBasic LLDP Configuration ExampleNetwork requirementsAs shown in Figure 1-4, the NMS and Switch A are located in the same Ethernet. An MED device andSwitch B are connected to GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 of Switch A.Enable LLDP on the ports of Switch A and Switch B to monitor the link between Switch A and Switch Band the link between Switch A and the MED device on the NMS.Figure 1-4 Network diagram for basic LLDP configurationzNMSSwitch AMEDSwitch BGE1/0/2 GE1/0/1GE1/0/1Configuration procedure1) Configure Switch A# Enable LLDP globally. system-view[SwitchA] lldp enable
