1-20Anti-interruption for Command InputAnti-interruption for command input refers to the feature that if your input is interrupted by system output,then after the completion of system output the system displays a command line prompt and your inputso far, and you can continue your operations from where you were stopped.Follow these steps to enable anti-interruption for command input:To do… Use the command… RemarksEnter system view system-view —Enable anti-interruption forcommand input info-center synchronous RequiredDisabled by defaultWith this feature enabled:z If you have no input at the command line prompt and the system outputs system information, forexample, logs, the system will not display the command line prompt after the outputs.z If the system outputs system information when you are typing interactive information (not YES/NOfor confirmation), the system will not redisplay the prompt information but a line break after theoutputs and then what you have typed.For information about the info-center synchronous command, refer to Information CenterConfiguration Commands.Saving ConfigurationsSome commands in the CLI of H3C switches are one-time commands, such as display commands,which display specified information, and the reset commands, which clear specified information. Thesecommands are executed one-time only and are not saved when the switch reboots.For other commands, after executing the commands, input the save command in any view to save allthe submitted and executed commands into the configuration file, and thus all saved configurations arenot lost when the switch reboot.
