1-16Task RemarksPerforming mCheck OptionalConfiguring the VLAN Ignore Feature OptionalConfiguring Digest Snooping OptionalConfiguring No Agreement Check OptionalConfiguring Protection Functions Optionalz Configurations made in system view take effect globally; configurations made in Layer 2 Ethernetport view take effect on the current port only; configurations made in port group view take effect onall member ports in the port group; configurations made in Layer 2 aggregate port view take effectonly on the aggregate port; configurations made on an aggregation member port can take effectonly after the port is removed from the aggregation group.z After you enable MSTP on a Layer 2 aggregate port, the system performs MSTP calculation on theLayer 2 aggregate port but not on the aggregation member ports. The MSTP enable state andforwarding state of each selected port in an aggregation group is consistent with those of thecorresponding Layer 2 aggregate port.z Though the member ports of an aggregation group do not participate in MSTP calculation, the portsstill reserve its MSTP configurations for participating MSTP calculation after leaving theaggregation group.Configuring MSTPConfiguring an MST RegionMake the following configurations on the root bridge and on the leaf nodes separately.Follow these steps to configure an MST region:To do... Use the command... RemarksEnter system view system-view —Enter MST region view stp region-configuration —Configure the MST regionname region-name nameOptionalThe MST region name is theMAC address by default.instance instance-id vlanvlan-listConfigure theVLAN-to-instance mappingtable vlan-mapping modulo moduloOptionalUse either command.All VLANs in an MST region aremapped to MSTI 0 by default.Configure the MSTP revisionlevel of the MST region revision-level level Optional0 by default
