H3C S5510 Series Command Manual

Also see for S3610 Series: Configuration Quick start Operation manual Operation manual Operation manual

Contents

H3C S5510 Series Command Manual Manual pdf 59 page image

Command Manual – AAA&RADIUS&HWTACACSH3C S3610&S5510 Series Ethernet SwitchesChapter 1 AAA & RADIUS & HWTACACSConfiguration Commands1-56z When the switch fails to communicate with the primary server due to some servertrouble, the switch will actively exchange packets with the secondary server.z After the time the primary server keeps in the block state exceeds the time set withthe timer quiet command, the switch will try to communicate with the primaryserver again when it has a RADIUS request. If the primary server recovers, theswitch immediately restores the communication with the primary server instead ofcommunicating with the secondary server, and at the same time restores thestatus of the primary server on the switch to the active state while keeping thestatus of the secondary server unchanged.z When both the primary and secondary servers are in the active state, the switchsends packets only to the primary server.Related command: radius scheme, primary authentication, secondaryauthentication, primary accounting and secondary accounting.Example# Set the status of the secondary authentication server in RADIUS scheme radius1 toactive. system-viewSystem View: return to User View with Ctrl+Z.[Sysname] radius scheme radius1New Radius scheme[Sysname-radius-radius1] state secondary authentication active1.2.26 stop-accounting-buffer enableSyntaxstop-accounting-buffer enableundo stop-accounting-buffer enableViewRADIUS scheme viewParameterNoneDescriptionUse the stop-accounting-buffer enable command to enable the switch to buffer thestop-accounting requests that bring no response.Use the undo stop-accounting-buffer enable command to disable the switch frombuffering the stop-accounting requests that bring no response.