86TFTP configuration commandsIn R1808P12 and later versions, the device supports the FIPS mode that complies with NIST FIPS 140-2requirements. Support for features, commands, and parameters might differ in FIPS mode and non-FIPSmode. For more information about FIPS mode, see Security Configuration Guide.TFTP is not supported in FIPS mode.display tftp client configurationUse display tftp client configuration to display the source IP address configuration of the TFTP client.Syntaxdisplay tftp client configuration [ | { begin | exclude | include } regular-expression ]ViewsAny viewDefault command level1: Monitor levelParameters|: Filters command output by specifying a regular expression. For more information about regularexpressions, see Fundamentals Configuration Guide.begin: Displays the first line that matches the specified regular expression and all lines that follow.exclude: Displays all lines that do not match the specified regular expression.include: Displays all lines that match the specified regular expression.regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.Usage guidelinesThe display tftp client configuration command displays the source IP address configuration of the TFTPclient. If the specified source IP address is active, this command displays the source IP address. If thespecified source interface is active, this command displays the source interface.Examples# Display the source IP address configuration of the TFTP client. display tftp client configurationThe source IP address is 192.168.0.123Related commandstftp client sourcetftp-server aclUse tftp-server acl to use an ACL to control the device' access to a specific TFTP server.Use undo tftp-server acl to restore the default.
