145Step Command Remarks2. Enter interface view.• Enter Layer 2 Ethernet interfaceview:interface interface-typeinterface-number• Enter Layer 2 aggregateinterface view:interface bridge-aggregationinterface-number• Enter S-channel interface view:interface s-channelinterface-number.channel-id• Enter S-channel aggregateinterface view:interfaceschannel-aggregationinterface-number:channel-id• The configuration made inLayer 2 Ethernet interface viewapplies only to the port.• The configuration made inLayer 2 aggregate interfaceview applies to the aggregateinterface and its aggregationmember ports. If the system failsto apply the configuration to anaggregation member port, itskips the port and moves to thenext member port. If the systemfails to apply the configurationto the aggregate interface, itstops applying theconfiguration to aggregationmember ports.• The configuration made inS-channel interface view orS-channel aggregate interfaceview applies only to theinterface. For more informationabout S-channel interfaces, seeEVB Configuration Guide.3. Configure the link type of theport as hybrid. port link-type hybrid By default, all ports are accessports.4. Assign the hybrid port to thespecified VLANs.port hybrid vlan vlan-id-list{ tagged | untagged }By default, the hybrid port is anuntagged member of the VLAN towhich the port belongs when itslink type is access.5. (Optional.) Configure thePVID of the hybrid port. port hybrid pvid vlan vlan-idBy default, the PVID of a hybridport is the ID of the VLAN to whichthe port belongs when its link typeis access.Configuring IP subnet-based VLANsIntroductionIn this method, packets are assigned to VLANs based on their source IP addresses and subnet masks. Aport configured with IP subnet-based VLANs assigns a received untagged packet to a VLAN based onthe source address of the packet.This feature is available only on hybrid ports, and it processes only untagged packets.Use this feature in the situation where packets from an IP subnet or IP address are required to betransmitted in a VLAN.
