184• To restore the default settings of the timers, H3C recommends restoring the Join timer first, followedby the Leave and LeaveAll timers.Table 11 Dependencies of the Join, Leave, and LeaveAll timersTimer Lower limit Upper limitJoin 20 centiseconds Half the Leave timerLeave Twice the Join timer LeaveAll timerLeaveAll Leave timer on each port 32760 centisecondsEnabling GVRP compatibilityPerform this task to enable GVRP compatibility for MVRP when the peer device supports GVRP, so that thelocal end can receive and send both MVRP and GVRP packets. For more information about GVRP, seerelevant protocols and standards.GVRP compatibility enables MVRP to work with STP or RSTP, but not MSTP. When MVRP with GVRPcompatibility enabled works with MSTP, the network might operate incorrectly.Disable the Period timer when you enable GVRP compatibility for MVRP. Otherwise, the VLAN statusmight frequently change when the system is busy.To enable GVRP compatibility:Step Command Remarks1. Enter system view. system-view N/A2. Enable GVRPcompatibility.mvrp gvrp-complianceenable By default, GVRP compatibility is disabled.Displaying and maintaining MVRPExecute display commands in any view and the reset mvrp statistics command in user view.Task CommandDisplay MVRP running status. display mvrp running-status [ interface interface-list ]Display the MVRP state of a port in aVLAN.display mvrp state interface interface-type interface-number vlanvlan-idDisplay MVRP statistics. display mvrp statistics [ interface interface-list ]Clear the MVRP statistics of specifiedports. reset mvrp statistics [ interface interface-list ]
