73XGE1/0/3 S 32768 1 {ACDEF}Remote:Actor Partner Priority Oper-Key SystemID Flag--------------------------------------------------------------------------------XGE1/0/1 1 32768 1 0x8000, 000f-e267-57ad {ACDEF}XGE1/0/2 2 32768 1 0x8000, 000f-e267-57ad {ACDEF}XGE1/0/3 3 32768 1 0x8000, 000f-e267-57ad {ACDEF}The output shows that:• Link aggregation group 1 is a non-load-shared Layer 3 dynamic aggregation group.• The aggregation group contains three Selected ports.Layer 3 edge aggregate interface configuration exampleNetwork requirementsAs shown in Figure 18, a Layer 3 dynamic aggregation group is configured on the device. The server isnot configured with dynamic link aggregation. Configure an edge aggregate interface so that bothTen-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 can forward packets to improve linkreliability.Figure 18 Network diagramConfiguration procedure# Create Layer 3 aggregate interface Route-Aggregation 1, and set the link aggregation mode todynamic. system-view[Device] interface route-aggregation 1[Device-Route-Aggregation1] link-aggregation mode dynamic# Configure an IP address and subnet mask for Layer 3 aggregate interface Route-Aggregation 1.[Device-Route-Aggregation1] ip address 192.168.1.1 24# Configure Layer 3 aggregate interface Route-Aggregation 1 as an edge aggregate interface.[Device-Route-Aggregation1] lacp edge-port[Device-Route-Aggregation1] quit# Assign Layer 3 Ethernet interfaces Ten-GigabitEthernet 1/0/1 and Ten-GigabitEthernet 1/0/2 toaggregation group 1.[Device] interface ten-gigabitethernet 1/0/1[Device-Ten-GigabitEthernet1/0/1] port link-aggregation group 1[Device-Ten-GigabitEthernet1/0/1] quit[Device] interface ten-gigabitethernet 1/0/2[Device-Ten-GigabitEthernet1/0/2] port link-aggregation group 1[Device-Ten-GigabitEthernet1/0/2] quit
