148Step Command Remarks5. Enter interface view.• Enter Layer 2 Ethernetinterface view:interface interface-typeinterface-number• Enter Layer 2 aggregateinterface view:interfacebridge-aggregationinterface-number• The configurations made in Layer 2Ethernet interface view apply only tothe port.• The configurations made in Layer 2aggregate interface view apply to theaggregate interface and itsaggregation member ports. If thesystem fails to apply the configurationsto the aggregate interface, it stopsapplying the configurations toaggregation member ports. If thesystem fails to apply the configurationsto an aggregation member port, itskips the port and moves to the nextmember port.6. Configure the port linktype as hybrid. port link-type hybrid By default, all ports are access ports.7. Assign the hybrid port tothe specifiedprotocol-based VLANs.port hybrid vlan vlan-id-list{ tagged | untagged }By default, the hybrid port is an untaggedmember of the VLAN to which the portbelongs when its link type is access.8. Associate the hybrid portwith the specifiedprotocol-based VLAN.port hybrid protocol-vlan vlanvlan-id { protocol-index [ toprotocol-end ] | all }By default, a port is not associated withany protocol-based VLANs.Displaying and maintaining VLANsExecute display commands in any view.Task CommandDisplay VLAN interface information.display interface [ vlan-interface ] [ brief [ down ] ]display interface [ vlan-interface [ interface-number ] ] [ brief[ description ] ]Display information about IP subnet-basedVLANs that are associated with the specifiedports.display ip-subnet-vlan interface { interface-typeinterface-number1 [ to interface-type interface-number2 ] |all }Display information about IP subnet-basedVLANs. display ip-subnet-vlan vlan { vlan-id1 [ to vlan-id2 ] | all }Display information about protocol-basedVLANs that are associated with the specifiedports.display protocol-vlan interface { interface-typeinterface-number1 [ to interface-type interface-number2 ] |all }Display information about protocol-basedVLANs. display protocol-vlan vlan { vlan-id1 [ to vlan-id2 ] | all }Display VLAN information. display vlan [ vlan-id1 [ to vlan-id2 ] | all | dynamic |reserved | static ]Display hybrid ports or trunk ports on thedevice. display port { hybrid | trunk }
