246• Service bridge mode—LLDP supports nearest bridge agents and nearest non-TPMR bridge agents.LLDP processes the LLDP frames with destination MAC addresses for these agents and transparentlytransmits the LLDP frames with other destination MAC addresses in the VLAN.• Customer bridge mode—LLDP supports nearest bridge agents, nearest non-TPMR bridge agents,and nearest customer bridge agents. LLDP processes the LLDP frames with destination MACaddresses for these agents and transparently transmits the LLDP frames with other destination MACaddresses in the VLAN.To configure the LLDP bridge mode:Step Command Remarks1. Enter system view. system-view N/A2. Configure LLDP to operatein service bridge mode. lldp mode service-bridge By default, LLDP operates incustomer bridge mode.Setting the LLDP operating modeStep Command Remarks1. Enter system view. system-view N/A2. Enter Layer 2/Layer 3Ethernet interface view,management Ethernetinterface view, or Layer2/Layer 3 aggregateinterface view.interface interface-type interface-number N/A3. Set the LLDP operatingmode.• In Layer 2/Layer 3 Ethernet interfaceview or management Ethernet interfaceview:lldp [ agent { nearest-customer |nearest-nontpmr } ] admin-status{ disable | rx | tx | txrx }• In Layer 2/Layer 3 aggregate interfaceview:lldp agent { nearest-customer |nearest-nontpmr } admin-status { disable| rx | tx | txrx }By default:• The nearest bridgeagent operates in txrxmode.• The nearest customerbridge agent andnearest non-TPMRbridge agent operate indisable mode.In Ethernet interface view, ifno agent type is specified,the command configuresthe operating mode fornearest bridge agents.In aggregate interfaceview, you can configure theoperating mode for onlynearest customer bridgeagents and nearestnon-TPMR bridge agents.
